D-Link DS-3550 Command Line Interface Reference Manual - page 137
129
config radius add
Description
The config radius add command is used to configure the settings
the switch will use to communicate with a RADIUS server.
Parameters
− Assigns a number to the current set of
RADIUS server settings. Up to 3 groups of RADIUS server settings
can be entered on the switch.
− The IP address of the RADIUS server.
key
− Specifies that a password and encryption key will be used
between the switch and the Radius server.
− The shared-secret key used by the RADIUS server
and the switch. Up to 32 characters can be used.
default
− Uses the default udp port number in both the “auth_port”
and “acct_port” settings.
auth_port
− The UDP port number for
authentication requests. The default is 1812.
acct_port
− The UDP port number for
accounting requests. The default is 1813.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To configure the RADIUS server communication setttings:
DES-3550:4#config radius add 1 10.48.74.121 key dlink default
Command: config radius add 1 10.48.74.121 key dlink default
Success.
DES-3550:4#
config radius delete
Purpose
Used to delete a previously entered RADIUS server configuration.
Syntax
config radius delete
Description
The config radius delete command is used to delete a previously
entered RADIUS server configuration.
Parameters
− Assigns a number to the current set of
RADIUS server settings. Up to 3 groups of RADIUS server settings
can be entered on the switch.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To delete previously configured RADIUS server communication settings: