D-Link DS-3550 Command Line Interface Reference Manual - page 145
137
config access_profile
syn | fin}]} | udp {src_port
0-65535>} | protocol_id
0x0-0xffffffff>
0xffffffff>
15
0x0-0xffffffff> | offset_16-31
0xffffffff>
0x0-0xffffffff> | offset_48-63
0xffffffff>
0xffffffff>
access_id
Description
The config access_profile command is used to configure an
access profile on the switch and to enter specific values that will be
combined, using a logical AND operation, with masks entered with
the create access_profile command, above.
Parameters
profile_id
− an integer between 1 and 8 that is used to
identify the access profile that will be deleted with this command.
This value is assigned to the access profile when it is created with
the create access_profile command.
add access_id
− Adds an additional rule to the above
specified access profile. The value specifies the relative priority of
the additional rule. The lower access ID, the higher the priority the
rule will be given.
ethernet
− Specifies that the switch will look only into the layer 2 part
of each packet.
•
vlan
− Specifies that the access profile will
apply to only to this VLAN.
•
source_mac
− Specifies that the access profile will
apply to only packets with this source MAC address.
•
destination_mac
− Specifies that the access profile
will apply to only packets with this destination MAC address.
•
802.1p
− Specifies that the access profile will
apply only to packets with this 802.1p priority value.
•
ethernet_type
− Specifies that the access
profile will apply only to packets with this hexadecimal 802.1Q
Ethernet type value in the packet header.
ip
− Specifies that the switch will look into the IP fields in each
packet.
•
vlan
− − Specifies that the access profile will
apply to only to this VLAN.
•
source_ip
− Specifies that the access profile will
apply to only packets with this source IP address.
•
destination_id
− Specifies that the access