D-Link DS-3550 Command Line Interface Reference Manual - page 138
130
DES-3550:4#config radius delete 1
Command: config radius delete 1
Success.
DES-3550:4#
config radius
Purpose
Used to configure the switch’s RADIUS settings.
Syntax
config radius
acct_port
Description
The config radius command is used to configure the switch’s
Radius settings.
Parameters
− Assigns a number to the current set of
RADIUS server settings. Up to 3 groups of RADIUS server settings
can be entered on the switch.
− The IP address of the Radius server.
key
− Specifies that a password and encryption key will be used
between the switch and the RADIUS server.
− The shared-secret key used by the RADIUS server
and the switch. Up to 32 characters can be used.
default
− Uses the default udp port number in both the “auth_port”
and “acct_port” settings.
auth_port
− The UDP port number for
authentication requests. The default is 1812.
acct_port
− The UDP port number for
accounting requests. The default is 1813.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To configure the RADIUS settings: