D-Link DS-3550 Command Line Interface Reference Manual - page 57
49
8
S
WITCH
U
TILITY
C
OMMANDS
The download/upload commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
download
[ firmware
configuration
config firmware
section_id
show
firmware_information
upload
[ configuration | log ] ping Each command is listed, in detail, in the following sections. download Purpose Used to download and install new firmware or a switch configuration file from a TFTP server. Syntax download[ firmware {increment} ] Description This command is used to download a new firmware or a switch configuration file from a TFTP server. Parameters firmware − Download and install new firmware on the switch from a TFTP server. configuration − Download a switch configuration file from a TFTP server. − The IP address of the TFTP server.
− The DOS path and filename of the firmware or switch configuration file on the TFTP server. For example, C:\3550.had. section_id hold two firmware versions for the user to select from, which are specified by section id. increment − Allows the download of a partial switch configuration file. This allows a file to be downloaded that will change only the switch parameters explicitly stated in the configuration file. All other switch parameters will remain unchanged. Restrictions The TFTP server must be on the same IP subnet as the switch. Only administrator-level users can issue this command. Example usage: