D-Link DS-3550 Command Line Interface Reference Manual - page 188
180
DES-3550:4#show authen server_host
Command: show authen server_host
IP Address Protocol Port Timeout Retransmit Key
--------------- -------- ----- ------- --------------- --------
10.53.13.94 TACACS 49 5 2 No Use
Total Entries : 1
DES-3550:4#
create authen server_group
Purpose
Used to create a user-defined authentication server group.
Syntax
create authen server_group
Description
This command will create an authentication server group. A server
group is a technique used to group tacacs/xtacacs/tacacs+ server
hosts into user defined categories for authentication using method
lists. The user may add up to eight (8) authentication server hosts to
this group using the config authen server_group command.
Parameters
define the newly created server group.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To create the server group “group_1”:
DES-3550:4#create server_group group_1
Command: create server_group group_1
Success.
DES-3550:4#
config authen server_group
Purpose
Used to create a user-defined authentication server group.
Syntax
config authen server_group [tacacs | xtacacs | tacacs+ |
15>] [add | delete] server_host
xtacacs | tacacs+]
Description This
command
will configure an authentication server group. A
server group is a technique used to group tacacs/xtacacs/tacacs+
server hosts into user defined categories for authentication using
method lists. The user may define the type of server group by
protocol or by previously defined server group. Up to eight (8)