D-Link DS-3550 Command Line Interface Reference Manual - page 72
64
DES-3550:4#config syslog host 1 severity all facility local0
Command: config syslog host all severity all facility local0
Success.
DES-3550:4#
Example usage:
To configure a syslog host for all hosts:
DES-3550:4#config syslog host all severity all facility local0
Command: config syslog host all severity all facility local0
Success.
DES-3550:4#
delete syslog host
Purpose
Used to remove a syslog host, that has been previously configured,
from the switch.
Syntax
delete syslog host [
Description
The delete syslog host command is used to remove a syslog host
that has been previously configured from the switch.
Parameters
− Specifies that the command will be applied to an index
of hosts. There are four available indexes, numbered 1 through 4.
all
− Specifies that the command will be applied to all hosts.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To delete a previously configured syslog host:
DES-3550:4#delete syslog host 4
Command: delete syslog host 4
Success.
DES-3550:4#
show syslog host
Purpose
Used to display the syslog hosts currently configured on the switch.
Syntax
show syslog host {
Description
The show syslog host command is used to display the syslog
hosts that are currently configured on the switch.