D-Link DS-3550 Command Line Interface Reference Manual - page 32
24
6
P
ORT
S
ECURITY
C
OMMANDS
The switch port security commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command Parameters
config port_security
ports
[
|max_learning_addr
[Permanent | DeleteOnTimeout | DeleteOnReset]}
delete port_security
entry
vlan_name clear port_security_entry port
show port_security {ports Each command is listed, in detail, in the following sections. config port_security ports Purpose Used to configure port security settings. Syntax config port_security ports [ disable] | max_learning_addr lock_address_mode [Permanent | DeleteOnTimeout | DeleteOnReset]} Description This command allows for the configuration of the port security feature. Only the ports listed in the Parameters portlist − specifies a port or range of ports to be configured. all − configure port security for all ports on the switch. admin_state [enable|disable] – enable or disable port security for the listed ports. max_learning_addr MAC addresses dynamically listed in the FDB for the ports. lock_address_mode[Permanent | DeleteOnTimout | DeleteOnReset] – Indicates the method of locking addresses. The user has three choices: Permanent – The locked addresses will not age out after the aging timer expires. DeleteOnTimeout – The locked addresses will age out after the aging timer expires. DeleteOnReset – The locked addresses will not age out until the switch has been reset. Restrictions Only administrator-level users can issue this command. Example usage: