D-Link DS-3550 Command Line Interface Reference Manual - Ip C
108
18
B
ASIC
IP C
OMMANDS
The IP interface commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config ipif
32> |state [enable | disable]} bootp |dhcp] show ipif Each command is listed, in detail, in the following sections. config ipif Purpose Used to configure the System IP interface. Syntax config ipif [ vlan dhcp] Description This command is used to configure the System IP interface on the switch. Parameters to identify this ip interface. − IP address and netmask of the IP interface to be created. You can specify the address and mask information using the traditional format (for example, 10.1.2.3|255.0.0.0 or in CIDR format, 10.1.2.3|8). − The name of the VLAN corresponding to the System IP interface. state [enable | disable] − Allows you to enable or disable the IP interface. bootp − Allows the selection of the BOOTP protocol for the assignment of an IP address to the switch’s System IP interface. dhcp − Allows the selection of the DHCP protocol for the assignment of an IP address to the switch’s System IP interface. Restrictions Only administrator-level users can issue this command. Example usage: To configure the IP interface System: