D-Link DS-3550 Command Line Interface Reference Manual - page 146
138
config access_profile
profile will apply to only packets with this destination IP
address.
•
dscp
− Specifies that the access profile will apply
only to packets that have this value in their Type-of-Service
(DiffServ code point, DSCP) field in their IP packet header.
•
priority
− Specifies that the access profile will
apply to packets that contain this value in their 802.1p priority
field of their header.
•
dscp
− Allows you to specify a value to be written
to the DSCP field of an incoming packet.
•
icmp
− Specifies that the switch will examine the Internet
Control Message Protocol (ICMP) field within each packet.
•
type
− Specifies that the access profile will
apply to this ICMP type value.
•
code
− Specifies that the access profile will
apply to this ICMP code.
•
igmp
− Specifies that the switch will examine the Internet
Group Management Protocol (IGMP) field within each packet.
•
type
− Specifies that the access profile will
apply to packets that have this IGMP type value.
•
tcp
− Specifies that the switch will examine the Transmission
Control Protocol (TCP) field within each packet.
•
src_port
− Specifies that the access profile
will apply only to packets that have this TCP source port in
their TCP header.
•
dst_port
− Specifies that the access profile
will apply only to packets that have this TCP destination port in
their TCP header.
•
flag_mask – Enter the type of TCP flag to be masked. The
choices are:
•
all: all flags are selected.
•
urg: TCP control flag (urgent)
•
ack: TCP control flag (acknowledgement)
•
psh: TCP control flag (push)
•
rst: TCP control flag (reset)
•
syn: TCP control flag (synchronize)
•
fin: TCP control flag (finish)
•
udp
− Specifies that the switch will examine the Universal