D-Link DS-3550 Command Line Interface Reference Manual - page 80
72
11
F
ORWARDING
D
ATABASE
C
OMMANDS
The layer 2 forwarding database commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameters
create fdb
create multicast_fdb config multicast_fdb config fdb aging_time delete fdb clear fdb [vlan show multicast_fdb {vlan show fdb {port config multicast port_filtering_mode [ forward_unregistered_groups | filter_unregistered_groups] show multicast port_filtering_mode { Each command is listed, in detail, in the following sections. create fdb Purpose Used to create a static entry to the unicast MAC address forwarding table (database) Syntax create fdb Description This command will make an entry into the switch’s unicast MAC address forwarding database. Parameters − The name of the VLAN on which the MAC address resides. − The MAC address that will be added to the forwarding table.
− The port number corresponding to the MAC destination address. The switch will always forward traffic to the specified device through this port. Restrictions Only administrator-level users can issue this command. Example usage: To create a unicast MAC FDB entry: