D-Link DS-3550 Command Line Interface Reference Manual - Sntp
145
23
T
IME AND
SNTP
C
OMMANDS
The Simple Network Time Protocol (SNTP) (an adaptation of the Network Time Protocol (NPT)) commands in the Command
Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command Parameters
config sntp
{primary 99999>} show sntp enable sntp disable sntp config time config time-zone {operator(1) [+ | -] | hour(2) 59>} config dst [disable | repeating {s-week hh:mm> | e-date time | offset [30 | 60 | 90 | 120]}]} show time Each command is listed, in detail, in the following sections. config sntp Purpose Used to setup SNTP service. Syntax config sntp {primary interval Description Use this command to configure SNTP service from an SNTP server. SNTP must be enabled for this command to function (See enable sntp). Parameters primary − This is the primary server the SNTP information will be taken from. − The IP address of the primary server. secondary − This is the secondary server the SNTP information will be taken from in the event the primary server is unavailable. − The IP address for the secondary server. poll-interval − This is the interval between requests for updated SNTP information. − The polling interval ranges from 30 to 99,999 seconds.