D-Link DS-3550 Command Line Interface Reference Manual - page 136
128
DES-3550:4#config 802.1x auth_mode mac_based
Command: config 802.1x auth_mode mac_based
Success.
DES-3550:4#
config 802.1x reauth
Purpose
Used to configure the 802.1x re-authentication feature of the switch.
Syntax
config 802.1x reauth {port_based ports [
mac_based [ports] [
Description
The config 802.1x reauthcommand is used to re-authenticate a
previously authenticated device based on port number.
Parameters
port_based – This instructs the switch to re-authorize 802.1x
functions based only on the port number. Ports approved for re-
authorization can then be specified.
mac_based ports
− This instructs the switch to re-authorize 802.1x
functions based only on the MAC address. MAC addresses
approved for re-authorization can then be specified.
− Specifies a port or range of ports to be re-authorized.
mac_address
authorized.
all
− Specifies all of the ports on the switch.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To configure 802.1x reauthentication for ports 1-18:
DES-3550:4#config 802.1x reauth port_based ports 1-18
Command: config 802.1x reauth port_based ports 1-18
Success.
DES-3550:4#
config radius add
Purpose
Used to configure the settings the switch will use to communicate
with a RADIUS server.
Syntax
config radius add 32> [default | {auth_port acct_port