D-Link DS-3550 Command Line Interface Reference Manual - page 54
46
disable snmp authenticate_traps
Parameters none.
Restrictions
Only administrator-level users can issue this command.
Example Usage:
To disable the SNMP authentication trap support:
DES-3550:4#disable snmp authenticate_traps
Command: disable snmp authenticate_traps
Success.
DES-3550:4#
config snmp system_contact
Purpose
Used to enter the name of a contact person who is responsible for
the switch.
Syntax
config snmp system_contact{
Description
The config snmp system_contact command is used to enter the
name and/or other information to identify a contact person who is
responsible for the switch. A maximum of 255 character can be
used.
Parameters
string is accepted if there is no contact.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To configure the switch contact to “
MIS D epart ment II
”:
DES-3550:4#config snmp system_contact MIS Department II
Command: config snmp system_contact MIS Department II
Success.
DES-3550:4#
config snmp system_location
Purpose
Used to enter a description of the location of the switch.
Syntax
config snmp system_location {
Description
The config snmp system_location command is used to enter a
description of the location of the switch. A maximum of 255