D-Link DS-3550 Command Line Interface Reference Manual - page 52
44
enable snmp traps
Syntax
enable snmp traps
Description
The enable snmp traps command is used to enable SNMP trap
support on the switch.
Parameters none.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To enable SNMP trap support on the switch:
DES-3550:4#enable snmp traps
Command: enable snmp traps
Success.
DES-3550:4#
enable snmp authenticate_traps
Purpose
Used to enable SNMP authentication trap support.
Syntax
enable snmp authenticate_traps
Description
This command is used to enable SNMP authentication trap support
on the Switch.
Parameters none.
Restrictions
Only administrator-level users can issue this command.
Example Usage:
To turn on SNMP authentication trap support:
DES-3550:4#enable snmp authenticate_traps
Command: enable snmp authenticate_traps
Success.
DES-3550:4#
show snmp traps
Purpose
Used to show SNMP trap support on the switch .
Syntax
show snmp traps
Description
This command is used to view the SNMP trap support status
currently configured on the Switch