Eclipse V12LD User Manual - 6.7.5 Attributes Menu
V-Series Panels| User Guide
Page 107
Pressing the Reply key or Reply key talk button will return you to the Get Label
menu.
6.7.5 ATTRIBUTES menu
The LOCAL PNL > ATTRIBUTES menu enables you to set the attributes of a
panel key to TALK, LISTEN, TALK + LSTN, TALK + FL or DUAL T+L.
Attribute
Description / comments
TALK
Sets a talk from this panel to a destination with no
automatic listen to the destination.
LISTEN
Sets a key to listen to the source without talking to the
destination at the same time. Use as a monitor key. Use
the volume level up/down buttons under the display (lever
key and pushbutton panels) or rotary control to increase
listen level.
TALK + LSTN
Sets a talk key with listen. Use the volume level up/down
buttons under the display (lever key and pushbutton
panel) or rotary encoder to increase or mute the listen
level.
TALK + FL
Sets a talk key with permanently made listen. Use the
volume level up/down buttons under the display (lever key
and pushbutton panels) or rotary encoder to increase or
mute the listen level.
DUAL T + L
Sets a dual talk and listen key (used only on pushbutton
panel types).
Press and hold to activate a talk and listen, or press and
release(less than 200ms) to latch a listen on the same
pushbutton.
Table 28 Available attributes in ATTRIBUTES menu
Note: To return to the SYS CONFIG menu, press the Reply key / Reply key talk
button (ATTRIBUTES).
6.7.6 REMOTE PNL menu
The REMOTE PNL menu enables you to program keys on a remote panel.
Select the remote panel from a list of available panels using the Sort Groups.
Note: You can only use the REMOTE PNL menu to program keys on other V-Series
panels. It cannot be used to program keys on other panel types.