Eclipse V12LD User Manual - page 149
V-Series Panels| User Guide
Page 149
The setting is held locally on the panel, which means that if the panel is moved
to another port on the system, the control delay setting comes with it. The
control delay must stay with the panel as it is based on geographical location,
and therefore the size of audio and control latency.
The control delay range is 0ms - 9999ms. The granularity of this setting is in
blocks of 50ms with the delay set being rounded down to the nearest multiple
of 50ms. For example, if less than 50ms is set no delay is applied. If a multiple
between 50 and 100ms is set, 50ms will be applied.
Note: Although the CNTL DELAY menu is accessed from the top level IP settings
menu, you can apply a delay to any type of connection to the matrix (enabling
it to be used on four-wire based VoICE unit connections).
Figure 6-117: Control delay menu on rack mounted panels
Figure 6-118: Control delay menu on desktop panels
Use the CLEAR key to clear the current control delay, and then enter the new
control delay.