Eclipse V12LD User Manual - page 151
V-Series Panels| User Guide
Page 151
The NET SETUP menu options are used to configure IP addresses and network
connection parameters:
Menu option
Description / comments
IP ADDRESS
Used to set the IP address of the panel.
IP GATEWAY
Used to set the IP address of the gateway that the panel
uses when connecting to the matrix.
DNS SERVER
Used to set the IP address of the Domain Name server
used by the panel.
LOGIN IP
Used to set the IP address of the matrix the panel will
connect to. The address refers to the IVC-32 card address
that is set up in ECS / EHX.
LOGIN PORT
Used to set up the IP port that the panel uses when
logging in to the matrix.
The login port must be the same as the port set up in ECS
/ EHX under System Preferences > IP Panels. When the
panel logs in, the panel will be sent the IP address and port
to use when communicating with the IVC-32 card. This is
configured in ECS / EHX under Matrix Hardware.
DHCP
Used to enable or disable DHCP (Dynamic Host
Configuration Protocol).
If enabled, the panel can be assigned an IP address,
subnet mask, gateway address and DNS server
automatically from the DHCP server rather than having to
manually configure the panel.
When DHCP is enabled, pushbutton panels will show the
DHCP pushbutton
flashing green
. Lever key panels will
show the talk/listen indicator
flashing green
. IVC-32
cards should be assigned automatically to ensure manually
assigned addresses do not clash with those assigned by
the DHCP server.
When DHCP is disabled, the panel can be configured
manually with network parameters including the DNS
server.
SUBNETMASK Used to set the subnet mask for the IP network the panel
is to be used on. Commonly the subnet mask will be
255.255.255.0.
CON TYPE
Used to determine the connection type (WAN (Wide Area
Network), LAN (Local Area Network) or INTERNET).
The connection type may determine whether DHCP and
DNS are used.
DNS/IP
Used to switch between DNS and IP server modes. In DNS
server mode, you can enter a login name for the IVC
server that the panel connects to. In IP server mode you
must enter the IP address of the IVC server.
Table 42: NET SETUP menu options