Eclipse V12LD User Manual - page 49
V-Series Panels | User Guide (draft, not yet released)
Page 49
Figure 4-27 Multi-Channel V-Series
2) Select 2 Channels. Two ports labeled Hosted Direct appear under the
V-Series Panel.
3) The Audio Mixer settings automatically set the default layout for one
extra IP channel.
Figure 4-28 Audio Mixer for two extra IP channels
Matrix 2 and Matrix 3 are the additional IP connections to the IVC-32.
The default mixer settings when two additional channels are selected
are to route Ext 0 to/from Matrix 2 and Ext 1 to/from Matrix 3. This
routing can be changed using the Audio Mixer. For more information
about the Audio Mixer, see the Eclipse HX Configuration Software User
Guide.
Note: If required, you can change the default settings. See 4.3.4
Advanced multi IP channel configurations.
4) Connect the V-Series Panel Matrix (Analogue) port to the one of the
ports in the IVC-32 card in the matrix using an RJ-45 crossover cable.
The pinouts are shown in the section above.
5) Connect the third-party cable harness as follows: