Eclipse V12LD User Manual - page 70
V-Series Panels | User Guide (draft, not yet released)
Page 70
5.17.3 Assignment Panel (AP) mode and the INTERCOM key
Assignment Panel (AP) mode is enabled in ECS / EHX. AP modeenables
you to add members to local partylines (conferences), local Fixed Groups, and
route local audio sources to IFBs.
Note: IFBs can be added to Fixed Groups in AP mode.
There are three ways to access AP mode on rotary panels:
Press Menu and then select ASSNMT PNL.
Press the dial pad 4 key (a shortcut to the ASSNMT PNL menu).
Press an assigned INTERCOM button.
You can assign a special INTERCOM button to any key on a rotary panel
including the Reply key in ECS / EHX. The position of the INTERCOM key on the
panel determines which buttons are available for making assignments and
which remain in intercom mode. This feature extends to expansion panels,
enabling you to perform intercom and assignment operations simultaneously.
When the INTERCOM key is selected, the panel enters Assignment Panel
(AP) mode without entering Menu mode. If you select an INTERCOM key that
has been placed on an expansion panel, then the expansion panel (and any
other expansion panels in the daisy chain) is placed in AP mode and can be
used normally.
You use the INTERCOM key in exactly the same way as the Reply key in Menu
mode when making assignments.
For detailed information about making assignments, and the appearance of the
panel displays, see6.13 ASSNMT PNL (Assignment Panel) menu
For more information about using the dial pad to perform tasks, see 5.11 Dial
Note: If the Reply key has not been reassigned in ECS / EHX, the talk button on the
Reply key will also flash when in AP mode, mimicking the INTERCOM key
status.
5.17.4 Rotary panel interruptible foldback (IFB) operation
When a rotary panel key is assigned as an IFB source, you can use the rotary
control to adjust the audio level sent from the panel to the destination or the
listen level at the panel.
If you latch the call to the IFB destination by momentarily pressing the talk
button, you can adjust the level of the audio sent to the IFB destination by
turning the rotary control.
If the call to the IFB destination is not latched (the talk button is held down)
the audio level is adjusted by pressing and turning the rotary control.