Eclipse V12LD User Manual - 4.3.3 Binaural Audio
V-Series Panels | User Guide
Page 52
4.3.3 Binaural audio
If you configure the panel for binaural audio, the following default mixer
settings appear in the panel Audio Mixer. This mode is useful for situations
when you require separate audio channels in the left and right headphone
inputs.
Figure 4-30 Audio Mixer for binaural
4.3.4 Advanced multi IP channel configurations
The additional one and two IP channel configurations automatically activate
default settings in the Audio Mixer when they are selected in the EHX software.
You can change these default settings to create a custom configuration. For
example, you can change the default routing in the Audio Mixer.
When port applications other than direct are selected for the hosted ports
panel, GPIOs will be automatically allocated by the software to provide the
requested functionality, for example call signal in the case of partyline. These
GPIOs will continue to be available in the EHX GPI and GPO screens and the
logic of the parallel usage will be OR'd.
For more information about using the Audio Mixer, see the EHX Configuration
Software User Guide.
4.4
Front panel connectors
The V-Series main panels have a microphone connection and a headset
connection on the front.
The microphone connection is always a three pin socket while the headset
connector may be an XLR-4M, XLR-5F or XLR-7M connector.
The pinouts for the connectors are given below.