Eclipse V12LD User Manual - page 27
V-Series Panels | User Guide (draft, not yet released)
Page 27
2) Rotate the front panel, so that the controls and display will face
upwards when wall mounted:
3) Remove the eight countersunk screws that hold the front of the panel
in place (the countersunk screws are located on the ends of the panel,
four on each end)
Note: Retain all the screws and remove the front panel assembly.
Figure 4-2: Countersunk screws in desktop panel
Note: The cables connecting the front panel electronics to the main
PCB are long enough to allow the panel front to be removed
and rotated without having to unplug any of the cables.
4) Rotate the front panel 180 degrees taking care not to pull on any of the
cables and reposition it. Ensure that no cables are trapped before
refitting the screws.
5) Apply pressure to the panel front to align the screw holes and fit the
top and bottom screws loosely on each side before fitting the remaining
screws and tightening all the screws.
When completed the front panel will be upside down when the panel
is standing on a flat surface.