Eclipse V12LD User Manual - page 41
V-Series Panels | User Guide (draft, not yet released)
Page 41
5
0V
18
0V
6
0V
19
0V
7
External Output 2
+ve
20
External Output 2 -ve
8
External Output 1
+ve
21
External Output 1 -ve
9
Hot MIC Output +ve
22
Hot MIC Output -ve
10
Auxiliary Loudspeaker
Output +ve
23
Auxiliary Loudspeaker Output -ve
11
External Input 2 +ve
24
External Input 2 -ve
12
External Input 1 +ve
25
External Input 1 -ve
13
0V
Table 8: Auxiliary connector pinout
Note: When wiring headset 2 to use the auxiliary audio connector, Clear-Com
recommends using good quality headphone cable to avoid pickup of electronic
noise by the microphone connection.
Wire the Headset 2 PTTs (pins 4 and 17) so that PTT connects the pin to
ground.
The auxiliary loudspeaker output is at line levels, and auxiliary loudspeakers
cannot be connected directly. Auxiliary loudspeakers must be driven through a
suitable audio amplifier. The line output levels are given in the product
specifications.
4.2.15 AES-3 option to AES-6 interface card
The AES-3 option module adds digital input and output using RJ-45 or coax to
V-Series main panels.
If the AES-3 digital interface option is used to connect the V-Series main panel
to the matrix it must be connected to an AES-6 Digital Interface instead of the
MVX-16 serial ports on the matrix.
Note: For more information about the AES-6 digital interface, see the AES-6
Manual.
Figure 4-18: V-Series panel with AES-3 connection
The pinout for the CAT5 cable to connect an AES-6-RJ to a V-Series panel AES-
3 interface is given in the table below.