Eclipse V12LD User Manual - page 148
V-Series Panels| User Guide
Page 148
Figure 6-116: Password setup menu for desktop panels
Use the PASSWORD menu to set up the password the panel uses to log into
the matrix. The password:
Must correspond to a password that has already been set up in ECS /
EHX for a port on an IVC-32 card (Matrix Hardware > Advanced
Settings >IP Panel Settings).
Is a string of up to ten characters (0 to 9 and A to F).
Enter up to ten characters using the up/down volume buttons (lever key and
pushbutton panels) or the talk button (rotary panels) to select the characters.
After each character has been selected the input will advance to the next
character. Pressing the lever key down, or the pushbutton, or the rotary
control will step back to the previous character.
When the password has been set up, exit the menu using the PASSWORD key
or talk button.
6.18.4 CNTL DELAY (Control Delay) menu
The CNTL DELAY (Control Delay) menu enables you to configure a delay on
key up processing for intercom keys.
The delay is only applied to dumb panel intercom page keys (keys used to
make or break of audio routes). Menu access keys are not affected.
You may want to apply a delay with certain audio links with multiple IP
encodes and decodes in place, as the link control data can overtake the audio
on the link resulting in truncation of the audio.
The default setting for a delay on key up processing is 0.