Eclipse V12LD User Manual - 5.16 Pushbutton Panels
V-Series Panels | User Guide (draft, not yet released)
Page 68
5.16 Pushbutton panels
Pushbuttons are either talk or listen keys, according to how they have been
assigned in ECS / EHX.
Pushbuttons normally default to latching unless the non-latching option is
configured in ECS / EHX under Global Settings (Latch Disable set to True)
for the destination port. In the default state (latching), pressing the button
momentarily latches the key.
If you hold the pushbutton for more than 200ms, the lever key does not latch
and the connection terminates as soon as the key is released.
When the pushbutton is inactive, the pushbutton is lit either
dim red
,
green
or
amber
(depending on whether it is configured as a talk (
red
), listen
(
green
) key, or talk and listen (
amber
) key.
When the pushbutton is active, the pushbutton is lit either
bright red
,
green
,
or
amber
, according to how it is assigned.
To cancel a connection, press the pushbutton. The button returns to dim
illumination.
An incoming call is signaled by a
flashing red
Reply pushbutton. To pick up
the call, press the Reply pushbutton.
5.16.1 Pushbutton Reply key GPI operation
Connecting a footswitch (or other type of switch) to GPI 3, which is pre-
assigned to the Reply key, the panel will not clear the item that is currently
being viewed on the reply stack when you release the switch.
You can use the Reply key up/down to scroll through the Reply key stack if
more than one call is present on the answerback stack. To move to the next
call, press the up button. To return to the previous call, press the down button.
For more details, see 7.2.13 Opto-isolated inputs and your ECS / EHX
documentation.
Note: For an audio block diagram for V-Series panels, see Figure 5-6: V-Series
audio block diagram. The diagram shows all the allowed audio routes and
valid crosspoints allowed by V-Series panels. Some of the audio paths shown
by the diagram are only available with the audio mixer function in ECS / EHX.
5.17 Rotary panels
Rotary panels can have talk and listen labels assigned to the same key in ECS /
EHX. The talk and listen functions are divided between the rotary control
(listen) and the pushbutton under the display (talk).
If the rotary control is pressed then the listen function is selected. The rotary
control light is lit
green
.
If the pushbutton (talk button) under the display is pressed, then the talk
function is selected and the talk button is lit
red
.
If listen is latched while talking, then the rotary control is lit
green
and the
pushbutton (talk button) is lit
red
.