Eclipse V12LD User Manual - Ifb Destination
V-Series Panels| User Guide
Page 131
To exit assignment mode all together, press the Reply key
again.
Table 37: Assignment menu modes
6.13.1 Assigning interruptible foldback (IFB) sources to an
IFB destination
Note: By default only one source per destination is configured. If multiple sources for
an IFB destination are required, then the option to assign multiple sources to
an IFB from an assignment panel (AP) must be enabled in your ECS / EHX
software. For more information, see your ECS/EHX documentation.
To assign a source to an IFB destination:
1) Press MENU to select it.
Press the ASSMNT PNL key to access the assignment menu. The
REPLY key status LED lights up
red
and displays the available
assignment modes.Toggle through the available assignment modes
using the reply keyuntil IFB ASSIGN is displayed. Valid IFB
destinations will
flash red
.
Only assignment modes that have been configured in the ECS /EHX
software will be available.
2) Press the appropriate key for the required IFB destination. The status
LED for the selected key is now lit
solid red
.
Note: Pressing the key again deactivates the assignment.
3) Valid IFB sources are indicated by the status LEDs
flashing green.
Press the appropriate key for the required IFB source. The status LED
for the selected key is now
solid green
and the source is assigned to
the destination.
4) Pressing the key again deactivates the assignment.
Note: To exit IFB assignment mode, press either the REPLY key or the MENU key.
6.13.1.1 Rotary panel IFB assignment using the INTERCOM key
On a rotary control panel, the INTERCOM key can be used to access the
assignment mode directly. See 5.17.3 in this manual for more information.
1) Press the INTERCOM key. The panel will enter Assignment Panel
mode and valid IFB destinations will flash
red
.
2) Follow steps 3 and 4 above.