Eclipse V12LD User Manual - page 62
V-Series Panels | User Guide (draft, not yet released)
Page 62
Figure 5-1: EHX Port List Options
5.10 Rotary control on rotary panels
The rotary control located next to the key window display on rotary panels is
used to adjust the volume on the connection. Turn the rotary control clockwise
to increase the volume and anticlockwise to decrease the volume.
Holding the talk key and turning the rotary adjusts the IFB send level.
You can also use the rotary control to release a telephone line, in the same
way as the TEL RELEASE function in the diagnostic menu.
To release the telephone line, press and hold the rotary control.
The label display changes to TEL RELEAS, and the telephone is put back on
the hook. All latched keys on the local system are unlatched, killing all routes
to the telephone. After approximately 5 seconds, the display starts displaying
the configured label again.
If the panel does not have Remote Line Release configured, then the call signal
is sent to the label instead.
Note: The rotary control is also used to adjust some settings that are accessed
through the panel menu, such as Sidetone Gain, and scrolling through lists.
5.11 Dial pad (2RU and desktop panels)
Use the dial pad on 2RU panels and desktop panels to:
Access some menu pages directly (as a shortcut).
Enter dialcodes, to dial out through a telephone interface, such as the
TEL-14 interface module.
The menu shortcuts available from the dial pad are as follows:
Dial pad
key
Menu shortcuts
1
Dial menu
2
Local Exclusive
3
Local page override
4
Assignment Panel menu
5
Local Key Assign menu
7
Local Preferences menu
8
Fast Key Assign menu
9
Diagnostics menu
Table 16: Dial pad menu shortcuts
When the dial pad keys are used to access a menu function, the
blue
menu
LED is lit.
5.12 Push-To-Talk (PTT) operation
Push-To-Talk (PTT) operation on V-Series panels is performed using a PTT
switch on either:
The panel headset.