Eclipse V12LD User Manual - page 43
V-Series Panels | User Guide (draft, not yet released)
Page 43
Note: The cable specifications are as stated previously unless the connections to the
3rd party network require different cable specifications. In this case the
customer should contact Clear-Com for advice.
4.2.16 T-Adapter option to DIG-2/DIF-102 interface
Note: The information in this section no longer applies to recent version of EHX
software.
The T-Adapter option module adds 2-wire digital input and output via RJ-45 to
V-Series main panels. If the T-Adapter digital interface option is used to
connect the V-Series main panel to the matrix it must be connected via a DIG-
2 Digital Interface instead of directly to an MVX-16 analog port on the matrix.
Note: For information on the DIG-2/DIF-102 digital interface, see the DIG-2 manual
and the Interface Module Frames manual.
Figure 4-20: Panel with T-Adapter interface
The pinout for the CAT5 cable to connect a DIG-2 interface to a V-Series panel
T-Adapter interface is given below.
Pin
Wire color
Description / function
1
White
/
Orange
not used
2
Orange
not used
3
White
/
Green
not used
4
Blue
Tx/Rx (+)
5
White
/
Blue
Tx/Rx (-)
6
Green
not used
7
White
/
Brown
not used
8
Brow
n
not used
Table 11: DIG-2-6 to panel wiring (T-Adapter interface)
The T-Adapter interface RJ45 connection is capable of operation with up to
3000m (10,000ft) of screened 24 AWG Cat5e cabling of 110 ohm +/- 10 ohm
impedance.