Eclipse V12LD User Manual - 4.6.4 Speaker Dim
V-Series Panels | User Guide (draft, not yet released)
Page 57
In this case, it will be necessary to turn the panel microphone gain down.
Similarly, in some noisy environments it may be necessary to turn the panel
microphone gain down and have the operator talk more closely into the
microphone.
Note: For information on adjusting panel microphone gain, see your ECS / EHX
documentation.
4.6.4 Speaker dim
When a panel microphone and a speaker are used together, feedback is
possible.
To reduce this possibility, the panel software will mute (turn down) the speaker
level by some predetermined amount when both the microphone and speaker
are enabled. The speaker mute can be adjusted from 0 to 15 dB (its default
setting is 6 dB).
Note: For information on adjusting speaker mute settings, see your ECS / EHX
documentation.
4.6.5 Page Override
When Page Override is assigned to a label, the audio level at the destination
panel(s) is predetermined.
This function enables you to talk to someone even if their panel volume control
is off (if the destination speaker was off, it will turn on).
The panel speaker output will operate at the predetermined level regardless of
the volume control setting, unless this control is set higher than the
predetermined level.
The page volume level can be adjusted from 0 to 10 in steps of 1 with 0 being
off and 10 being full volume. The page volume level’s default setting is 5.
Note: For information about enabling Page Override, see your ECS / EHX
documentation.
4.7
Panel-to-matrix card baud rate
The RS-422 serial data communication between a panel and other devices
operates at 19.2 k baud by default.