Eclipse V12LD User Manual - page 56
V-Series Panels | User Guide (draft, not yet released)
Page 56
Figure 4-35: DIP switch location (headset detect)
Headset 1 auto detect is controlled by switch 1 on SW2 and headset 2 auto
detect is controlled by switch 2 on SW2.
Figure 4-36: Headset detect DIP switch settings
To enable headset auto detect for a headset set the appropriate switch to ON
(towards the front of the panel).
To disable headset auto detect set the appropriate switch to OFF (towards the
rear of the panel).
4.6.3 Panel microphone gain
The preamplifier gain of the panel microphone can be adjusted over a range of
+20 to +70 dB; the panel microphone gain’s default setting is 50 dB. However,
if two panels are talking to each other at the same time with the panel
microphone gain set to maximum, feedback may occur even if the speaker dim
is set to maximum in ECS / EHX.