Eclipse V12LD User Manual - 6.14 Supervise Menu
V-Series Panels| User Guide
Page 134
2) Press the ASSMNT PNL key and use the REPLY key to toggle to the
Fixed Group (FG) mode. In Fixed Group assignment mode all available
Fixed Group status LEDs,
flash red
.
Note: Only assignment modes that have been configured in the ECS
/EHX software will be available.
3) Press the key for the required Fixed Group.
The key’s status LED is lit
solid red
and all available members’ status
LEDs
flash green
. In the case of rotary panels, if a talk label is
available the talk button will flash green and if a listen label is available
the rotary encoder will flash green.
4) Press a key with the associated flashing green status LED of an
available member to add it to the Fixed Group.
The key’s status LED becomes
solid green
to indicate the member has
been added to the Fixed Group.
5) Repeat step 4 until the Fixed Group contains all desired members.
Note: To remove a member from the Fixed Group, press that
member’s key. The solid green status LED associated with that
key
flashes green
to indicate it is available again.
6) To exit Fixed Group assignment mode, press either the REPLY key or
the MENU key.
6.14 SUPERVISE menu
The SUPERVISE menu can be accessed either via an assigned ‘hot key’ (see
6.14.1.3 in this manual) on the panel or via the MENU system.
The SUPERVISE menu allows the user to select another panel to supervise
from the panels listed in the sort groups.
Note: The target panel cannot be the current panel (an error message will be
displayed if this is selected) and must be a V-Series panel with the same
number of keys or fewer keys than the supervising panel.
Note: The supervise option must be enabled in EHX, otherwise this menu option is
not displayed. This checkbox is found in Hardware/Cards and
Ports/Properties/Menu Options within the EHX configuration software.