Eclipse V12LD User Manual - 4.2.17 Lan Connector
V-Series Panels | User Guide (draft, not yet released)
Page 44
If 26 AWG screened CAT5e cable is used the maximum cable run is reduced to
2,200m (7,300ft).
Note: A ferrite core must be added to the socket end of each cable. A suitable ferrite
core is Würth Electronik part: 74271132.
4.2.17 LAN connector
The LAN connector is an industry standard RJ45 socket that enables you to
connect the panel to either a network or the Ethernet port of a PC. The LAN
connection is reserved for panel firmware upgrades and future use. This port
can support connection of panel to matrix with one, two or three audio
channels.
Figure 4-21: LAN connector pinout
4.2.18 Expansion panel output
V-Series main panels have an industry standard RJ45 socket allowing up to
eight V Series expansion panels to be daisy chained from it.