Eclipse V12LD User Manual - page 50
V-Series Panels | User Guide (draft, not yet released)
Page 50
Male DB-25 connector to Control on V-Series panel
Female DB-25 connector to Aux.Audio on V-Series panel.
The pinouts for this connector are shown on the next page.
By default, the extra IP channels are configured as Direct, which is used for a
4-wire connection. You can change this to make it suitable for a different
application.
1) In the EHX software, Navigate to Cards and Ports, and select the
added IP port.
2) From the right-hand side of the window, select Basic Options.
3) From the Module Application list box, select from
Partyline – to connect to an analogue partyline by using the CCI-22
Interface Module.
Two-Way Radio – to connect to a third-party two-way radio system
by using the FOR 22 Interface Module.
Direct – to connect to a 4-wire interface.
HelixNet – to connect to the digital HelixNet partyline.
By default, the extra IP channel is configured as Direct, which is used for a 4-
wire connection. You can change this to make it suitable for a different
application.
A partyline, two-way radio or HelixNet interface connected to EXT 0 in this way
provides the same functionality as the same interface connected directly to an
MVX port, for example; call signaling, Tx and Rx, in the case of the Partyline
port application setting.
With this default mixer setting FOR-22 or CCI-22 can be connected to EXT0
and EXT1. This setting supports both Call signaling and/or PTT signaling to the
external device.