EDAN iM80 User Manual - page 142
Patient Monitor User Manual Care and Cleaning
- 131 -
2
If liquid is splashed on or into the main unit inadvertently, or enters the conduit, stop
using the monitor and contact the manufacturer for service immediately.
Clean the monitor enclosure with soft cloth and diluent non-caustic detergents recommended
above.
Clean the screen with a dry soft cloth.
Clean the touch screen with a soft cloth and neutral detergent or isopropyl alcohol. Do not use
chemical solvents, acidic or alkali solutions.
CAUTION
1
Although the monitor is chemically resistant to most common hospital cleaners and
non-caustic detergents, different cleaners are not recommended and may stain the
monitor.
2
Many cleansers must be diluted before use. Follow the manufacturer’s directions
carefully to avoid damaging the monitor.
3
Don’t use strong solvent, for example, acetone.
4
Never use an abrasive such as steel wool or metal polish.
5
Do not allow any liquid to enter the product, and do not immerse any part of the
monitor into any liquid.
6
Avoid pouring liquids on the monitor while cleaning.
7
Don’t remain any cleaning solution on the surface of the monitor.
NOTE:
1
The monitor surface can be cleaned with hospital-grade ethanol and dried in air or
with crisp and clean cloth.
2
The manufacturer has no responsibility for the effectiveness of controlling infectious
disease using these chemical agents. Please contact infectious disease experts in
your hospital for details.
25.2.2 Cleaning the Accessories
25.2.2.1 Cleaning the ECG Cables and Lead Wires
NOTE:
1. Use only recommended cleaning substances and disinfectants listed in this document.
Others may cause damage (not covered by warranty), reduce product lifetime or
cause safety hazards.
2. Keep the cable and lead wires free of dust and dirt.