EDAN iM80 User Manual - Chapter 7 User Interface
Patient Monitor User Manual User Interface
- 49 -
Chapter 7 User Interface
7.1 Setting Interface Style
The user can set the interface based on the requirement, and the set options include the following:
Sweep of the waveform.
Parameters needing to be monitored.
Change to some settings may have the risk, so only the authorized person can change them. After
changing the settings, please notify the operator.
7.2 Selecting Display Parameters
The user can select the display parameters based on the monitoring and measurement
requirements. To select the parameter, please:
1. Select Menu > System Setup > Module Switch.
2. Select the required parameters from the popup interface.
3. Press Exit to exit the menu and the screen will adjust the parameters automatically.
7.3 Changing Waveform Position
The user can exchange the waveform positions of parameter A and parameter B, please refer to
the following steps to do so:
1. Select waveform A and open the setup menu of waveform A.
2. Select Change from the popup menu and select the desired label name of waveform B from
the pull-down list.
7.4 Changing Interface Layout
To change the interface layout, please refer to the following steps:
1. Select Menu > Display Setting.
2. Select one interface from the popup menu.
3. The user can implement one kind of function screen based on the requirements. If the user
selects the Large Font option, there is no function screen to be selected.
7.5 Viewing Trend Screen
To view the short trend screen, the user can press the Trend Screen key on the screen directly or
select Menu > Display Setting > View Selection > TrendScreen.
7.6 Viewing Oxygen Screen
To view the oxygen screen, the user can press the oxyCRG key on the screen or select Menu >
Display Setting > View Selection > oxyCRG. This interface is always used in NICU because
the SpO
2
, HR and Resp of the neonate are different from those of adults.