Jeep Cherokee 2000 Service Manual - page 1059
INSTALLATION
(1) Route replacement cable behind instrument
panel and under floor console area to shift mecha-
nism (Fig. 80).
(2) Insert cable end into opening in steering col-
umn hub under ignition lock. Push cable inward
until lock tab engages.
(3) Connect the cable end eyelet onto shifter
bellcrank pin.
(4) Place gear selector in PARK.
(5) Push the spring-loaded cable adjuster forward
and snap cable into bracket.
(6) Adjust the brake transmission shifter interlock
cable. Refer to the Adjustment portion of this section
for proper procedures.
(7) Verify that the cable adjuster lock clamp is
pushed downward to the locked position.
(8) Test the park-lock cable operation.
(9) Install the floor console and related trim.
(10) Install tie strap to hold cable to base of steer-
ing column.
(11) Install lower steering column shroud and igni-
tion lock.
(12) Install lower steering column cover.
VALVE BODY
REMOVAL
(1) Raise vehicle.
(2) Remove oil pan and drain fluid.
(3) Loosen clamp bolts and remove throttle and
manual valve levers from manual lever shaft.
(4) Remove park/neutral position switch.
(5) Remove filter from valve body.
(6) Depress retaining clip and pull solenoid wire
from case connector (Fig. 81).
(7) Remove valve body attaching screws.
(8) Lower valve body enough to remove accumula-
tor piston and piston spring (Fig. 82).
Fig. 80 Cable and Shifter
1 – SHIFT MECHANISM
2 – LOCK-TAB
3 – IGNITION LOCK INTERLOCK
4 – STEERING COLUMN
5 – SOLENOID
6 – WIRE CONNECTOR
7 – LEVER
8 – MOUNT BRACKET
9 – SHIFT CABLE
10 – AUTOMATIC TRANSMISSION
11 – TIE STRAP
12 – PARK/BRAKE INTERLOCK CABLE
XJ
AUTOMATIC TRANSMISSION—30RH
21 - 151
REMOVAL AND INSTALLATION (Continued)