Jeep Cherokee 2000 Service Manual - page 1165
INSTALLATION
(1) Route
replacement
cable
behind
instrument
panel and under floor console area to shift mechanism
(Fig. 58).
(2) Insert cable end into opening in steering column
hub under ignition lock. Push cable inward until lock
tab engages.
(3) Connect
the
cable
end
eyelet
onto
shifter
bellcrank pin.
(4) Place gear selector in PARK.
(5) Push the spring-loaded cable adjuster forward
and snap cable into bracket.
(6) Adjust the brake transmission shifter interlock
cable. Refer to the Adjustment portion of this section
for proper procedures.
(7) Verify that the cable adjuster lock clamp is
pushed downward to the locked position.
(8) Test the park-lock cable operation.
(9) Install the floor console and related trim.
Fig. 58 Cable and Shifter
1 – SHIFT MECHANISM
2 – LOCK-TAB
3 – IGNITION LOCK INTERLOCK
4 – STEERING COLUMN
5 – SOLENOID
6 – WIRE CONNECTOR
7 – LEVER
8 – MOUNT BRACKET
9 – SHIFT CABLE
10 – AUTOMATIC TRANSMISSION
11 – TIE STRAP
12 – PARK/BRAKE INTERLOCK CABLE
Fig. 57 Brake/Park Interlock Cable
1 – IGNITION LOCK
2 – LOCK TAB
3 – CABLE END
XJ
AW–4 AUTOMATIC TRANSMISSION
21 - 257
REMOVAL AND INSTALLATION (Continued)