Jeep Cherokee 2000 Service Manual - page 1202
(77) Check clutch and brake operation. Operate
clutches and brakes with compressed air applied
through feed holes in case (Fig. 184). Listen for
clutch and brake application. If you do not hear a
clutch or brake apply, disassemble transmission and
repair fault before proceeding. It is necessary to
block the overdrive clutch accumulator feed
hole No. 8 (Fig. 184) in order to check direct
clutch operation.
(78) Lubricate and install new O–rings on accumu-
lator pistons (Fig. 185).
(79) Assemble and install accumulator pistons and
springs (Fig. 185).
(80) Install new check ball body and spring (Fig.
186).
(81) Position valve body on case (Fig. 187).
(82) Install detent spring (Fig. 187).
(83) Align manual valve, detent spring and shift
sector (Fig. 187).
(84) Connect transmission throttle cable to throttle
valve cam (Fig. 188).
(85) Install and tighten valve body–to–case bolts to
10 N·m (7 ft. lbs.) torque.
(86) Connect valve body solenoid wires to solenoids
(Fig. 189).
(87) Install
new
O–ring
on
solenoid
harness
adapter and secure adapter to case.
(88) Install valve body oil tubes (Fig. 190). Tap
tubes into place with a plastic mallet. Be sure the
Fig. 184 Clutch And Brake Feed Hole Locations
Fig. 185 Accumulator Piston And Spring Installation
Fig. 186 Installing Check Ball Body And Spring
1 – CHECK BALL BODY AND SPRING
21 - 294
AW–4 AUTOMATIC TRANSMISSION
XJ
DISASSEMBLY AND ASSEMBLY (Continued)