Jeep Cherokee 2000 Service Manual - page 1384
REMOVAL
(1) Slide the front seats all the way forward for
access to the belt anchor bolt.
(2) Disconnect the belt wire harness connector.
(3) Remove the anchor bolt cover.
(4) Remove the anchor bolt attaching the buckle to
the seat.
(5) Remove the turning loop cover concealing the
shoulder belt upper anchor bolt.
(6) Use a Torx bit to remove the upper anchor bolt
(Fig. 73). Remove the support/guide washer.
(7) Remove the inner scuff plate/trim panel from
the door sill and remove the shoulder belt lower
anchor bolt(s) with a Torx bit (Fig. 74) and (Fig. 75).
(8) Remove the shoulder belt and the retractor.
INSTALLATION
(1) Position the shoulder belt retractor in the
shield and install the lower anchor bolt with a Torx
bit. Tighten bolt to 43 N·m (32 ft. lbs.) torque.
(2) Position the support/guide washer and shoulder
belt upper anchor plate on the trim panel. Install the
upper anchor bolt with a Torx bit.
(3) Route belt through trim panel.
(4) Tighten the upper and lower anchor bolts to 43
N·m (32 ft. lbs.) torque.
(5) Install the door sill inner scuff plate/trim panel
and install the cap over the upper anchor bolt.
(6) Install the shoulder belt buckle and anchor
bolt. Connect the wire harness connectors. Tighten
the buckle anchor bolt to 43 N·m (32 ft. lbs.) torque.
Fig. 72 Liftgate Scuff Plate
1 – LIFTGATE SCUFF PLATE
Fig. 73 Anchor Bolt
1 – TRIM PANEL
2 – TURNING LOOP
3 – BELT
4 – ADJUSTER
Fig. 74 Front Shoulder Belt—2-Door Vehicles
1 – ADJUSTER
2 – TRIM PANEL
3 – TURNING LOOP
4 – RETRACTOR
5 – TRIM PANEL
23 - 56
BODY
XJ
REMOVAL AND INSTALLATION (Continued)