Jeep Cherokee 2000 Service Manual - page 1171
(8) Pry shaft seals out of case (Fig. 78).
INSTALLATION
(1) Inspect the manual valve shaft and sector.
Replace either component if worn or damaged.
(2) Coat replacement shaft seals with petroleum
jelly and seat them in the case using an appropri-
ately sized driver/socket (Fig. 79).
(3) Install new spacer sleeve on sector (Fig. 80).
(4) Lubricate manual valve shaft with petroleum
jelly and install it through the left side of the trans-
mission case.
Fig. 77 Cutting Spacer Sleeve
1 – SPACER
2 – MANUAL VALVE SHAFT
Fig. 78 Removing Manual Valve Shaft Seals
1 – MANUAL VALVE SHAFT SEAL
Fig. 79 Installing Manual Valve Shaft Seals
1 – SHAFT SEAL INSTALLER
Fig. 80 Installing Spacer Sleeve On Sector
1 – SHIFT SECTOR
2 – SPACER SLEEVE
XJ
AW–4 AUTOMATIC TRANSMISSION
21 - 263
REMOVAL AND INSTALLATION (Continued)