Jeep Cherokee 2000 Service Manual - page 224
INSTALLATION
(1) Be sure reservoir cover on clutch master cylin-
der is tight to avoid spills.
(2) Position clutch linkage components in vehicle.
Work connecting line and slave cylinder downward
past engine and adjacent to clutch housing (Fig. 16)
or (Fig. 17).
(3) Position clutch master cylinder on dash panel
(Fig. 16) or (Fig. 17).
(4) Attach clutch master cylinder actuator to pivot
pin on clutch pedal (Fig. 18).
(5) Install and tighten clutch master cylinder
attaching nuts to 38 N·m (28 ft. lbs.) torque.
(6) Raise vehicle.
(7) Insert slave cylinder push rod through clutch
housing opening and into release lever. Be sure cap
on end of rod is securely engaged in lever. Check this
before installing cylinder attaching nuts.
(8) Install and tighten slave cylinder attaching
nuts to 23 N·m (17 ft. lbs.) torque.
Fig. 15 Slave Cylinder
1 – CLUTCH SLAVE CYLINDER
Fig. 16 Left Hand Drive Clutch Master Cylinder
1 – CLUTCH MASTER CYLINDER
Fig. 17 Right Hand Drive Clutch Master Cylinder
1 – CLUTCH MASTER CYLINDER
Fig. 18 Clutch Pedal Attachment
1 – CLUTCH MASTER CYLINDER
6 - 14
CLUTCH
XJ
REMOVAL AND INSTALLATION (Continued)