Jeep Cherokee 2000 Service Manual - page 1189
138) for bearing and race location and correct posi-
tioning.
(3) Install new seals onto the No.1 first-reverse
brake piston. Lubricate seals with transmission fluid.
(4) Install the No.1 first-reverse brake piston into
the transmission case.
(5) Install new seal onto the first-reverse brake
piston reaction sleeve. Lubricate seals with transmis-
sion fluid.
(6) Install the first-reverse brake piston reaction
sleeve into the transmission case.
(7) Install new seal onto the No.2 first-reverse
brake piston. Lubricate seals with transmission fluid.
(8) Install the No.2 first-reverse brake piston into
the transmission case.
(9) Install the spring plate into the No.2 first-re-
verse brake piston.
(10) Install Spring Compressor 7539 onto the first-
reverse brake piston.
(11) Compress the first-reverse brake piston spring
and install the first-reverse brake piston snap-ring.
(12) Remove Spring Compressor 7539.
(13) Install rear planetary gear, second brake
drum and output shaft as outlined in following steps:
(14) Verify No. 10 thrust bearing and race (Fig.
138). Bearing and race outer diameter is 57.7 mm
(2.272 in.) and inside diameter is 39.2 mm (1.543 in.).
(15) Coat thrust bearing and race assembly with
petroleum jelly and install in case (Fig. 139). Race
faces down. Bearing rollers face up.
(16) Align teeth of second brake drum and clutch
pack (Fig. 140).
Fig. 138 Thrust Bearing Chart
XJ
AW–4 AUTOMATIC TRANSMISSION
21 - 281
DISASSEMBLY AND ASSEMBLY (Continued)