Jeep Cherokee 2000 Service Manual - page 1269
(9) Using Remover C-4210 and Handle C-4171,
drive input shaft bearing from inside the annulus
gear opening in the case. (Fig. 49).
(10) Install locating ring on new bearing.
(11) Position case so forward end is facing upward.
(12) Using Remover C-4210 and Handle C-4171,
drive input shaft bearing into case. The bearing
locating ring must be fully seated against case sur-
face (Fig. 50).
(13) Remove input gear pilot bearing by inserting
a suitably sized drift into the splined end of the input
gear and driving the bearing out with the drift and a
hammer (Fig. 51).
(14) Install new pilot bearing with Installer 5065
and Handle C-4171 (Fig. 52).
Fig. 46 Output Shaft Rear Bearing Removal
1 – REAR CASE
2 – SPECIAL TOOL L-4454–1 AND L-4454–3
3 – SPECIAL TOOL 8148
Fig. 47 Output Shaft Rear Bearing Installation
1 – HANDLE C-4171
2 – OUTPUT SHAFT INNER BEARING
3 – INSTALLER 5066
Fig. 48 Output Shaft Rear Bearing Installation Depth
1 – BEARING (SEATED) AT LOWER EDGE OF CHAMFER
2 – CHAMFER
Fig. 49 Input Shaft Bearing Removal
1 – SPECIAL TOOL C-4171
2 – SPECIAL TOOL C-4210
XJ
NV231 TRANSFER CASE
21 - 361
DISASSEMBLY AND ASSEMBLY (Continued)