Jeep Cherokee 2000 Service Manual - page 1143
OPERATION
The principal which makes this operation possible
is known as Pascal’s Law. Pascal’s Law can be stated
as: “Pressure on a confined fluid is transmitted
equally in all directions and acts with equal force on
equal areas.”
PRESSURE
Pressure (Fig. 31) is nothing more than force (lbs.)
divided by area (in or ft.), or force per unit area.
Given a 100 lb. block and an area of 100 sq. in. on
the floor, the pressure exerted by the block is: 100
lbs. 100 in or 1 pound per square inch, or PSI as it is
commonly referred to.
PRESSURE ON A CONFINED FLUID
Pressure is exerted on a confined fluid (Fig. 32) by
applying a force to some given area in contact with
the fluid. A good example of this is a cylinder filled
with fluid and equipped with a piston that is closely
fitted to the cylinder wall. If a force is applied to the
piston, pressure will be developed in the fluid. Of
course, no pressure will be created if the fluid is not
confined. It will simply “leak” past the piston. There
must be a resistance to flow in order to create pres-
sure.
Piston
sealing
is
extremely
important
in
hydraulic operation. Several kinds of seals are used
to accomplish this within a transmission. These
include but are not limited to O–rings, D–rings, lip
seals, sealing rings, or extremely close tolerances
between the piston and the cylinder wall. The force
exerted is downward (gravity), however, the principle
remains the same no matter which direction is taken.
Fig. 29 Accumulators
1 – OVERDRIVE CLUTCH
2 – SECOND BRAKE
3 – DIRECT CLUTCH
4 – OVERDRIVE BRAKE
Fig. 30 Transmission Valve Body Solenoids
Fig. 31 Force and Pressure Relationship
XJ
AW–4 AUTOMATIC TRANSMISSION
21 - 235
DESCRIPTION AND OPERATION (Continued)