Jeep Cherokee 2000 Service Manual - page 1343
BUCKET SEAT
REMOVAL
(1) Remove bolts attaching seat to floor pan (Fig.
7).
(2) Remove nut attaching seat to floor pan.
(3) For power seat, disconnect wire harness con-
nector. If equipped, disconnect wire harness for
heated seat.
(4) Disconnect seat belt buckle warning wire har-
ness connector.
(5) Separate seat from floor panel.
INSTALLATION
(1) Position seat on floor pan.
(2) Connect seat belt buckle warning wire harness
connector.
(3) For power seats, connect wire harness connec-
tor. If equipped, connect harness for heated seat.
(4) Install front fasteners attaching seat to floor
pan. Tighten to 27 N·m (20 ft. lbs.) torque.
(5) Install rear fasteners attaching seat to floor
pan. Tighten to 27 N·m (20 ft. lbs.) torque.
(6) Install nut attaching seat to floor pan. Tighten
to 40 N·m (30 ft. lbs.) torque.
BUCKET SEAT TRACK
REMOVAL
NOTE: If the vehicle is equipped with manually
adjusted bucket seats, the inboard or outboard seat
track may be serviced separately.
(1) Remove bucket seat from vehicle.
(2) Remove screws attaching the side shield trim
cover from the seat.
(3) If equipped, disengage the power seat connec-
tor from the power seat switch.
(4) Remove the nuts attaching the seat track to
the bucket seat platform.
(5) When separating the seat track from the plat-
form, route the power seat switch connector through
the access hole in the seat cushion frame, if
equipped.
INSTALLATION
(1) While positioning the seat track on the bucket
seat platform, route the power seat switch connector
through the access hole in the seat cushion frame, if
equipped.
(2) Install the nuts attaching the seat track to the
bucket seat platform.
(3) If equipped, engage the power seat connector to
the power seat switch.
(4) Install screws attaching the side shield trim
cover to the seat.
(5) Install bucket seat.
BUCKET SEAT PLATFORM
Bucket seat platforms are not repairable. If the
seat platform is damaged, replace platform as a unit.
Fig. 6 Head Restraint Cover
1 – HEAD RESTRAINT COVER
2 – HEAD RESTRAINT CUSHION
Fig. 7 Bucket Seat—Power Seat
1 – NUT
2 – DRIVER SIDE FRONT SEAT
3 – SCREW
4 – STUD
5 – SCREW
XJ
BODY
23 - 15
REMOVAL AND INSTALLATION (Continued)