Jeep Cherokee 2000 Service Manual - page 7
SPECIFICATIONS
FLUID CAPACITIES
FUEL TANK
All . . . . . . . . . . . . . . . . . . . . . . . . 76.4 L (20.2 gal.)
ENGINE OIL W/FILTER CHANGE
2.5L . . . . . . . . . . . . . . . . . . . . . . . . . 3.8 L (4.0 qts.)
4.0L . . . . . . . . . . . . . . . . . . . . . . . . . 5.7 L (6.0 qts.)
COOLING SYSTEM
2.5L . . . . . . . . . . . . . . . . . . . . . . . . . 9.5 L (10 qts.)*
4.0L . . . . . . . . . . . . . . . . . . . . . . . 11.4 L (12 qts.)**
*Includes 2.2 L (2.3 qts) for coolant recovery reser-
voir.
**Includes 0.9 L (1.0 qt) for coolant recovery reser-
voir.
AUTOMATIC TRANSMISSION
Dry fill capacity*
AW4 . . . . . . . . . . . . . . . . . . . . . . . . 7.8 L (16.5 pts.)
30RH . . . . . . . . . . . . . . . . . . . . . . . 4.67 L (9.86pts.)
*Depending on type and size of internal cooler,
length and inside diameter of cooler lines, or use of an
auxiliary cooler, these figures may vary. Refer to
Group 21, Transmission for proper fluid fill procedure.
MANUAL TRANSMISSION
AX5 (4X2) . . . . . . . . . . . . . . . . . . . . 3.5 L (3.7 qts.)
AX5 (4X4) . . . . . . . . . . . . . . . . . . . . 3.3 L (3.5 qts.)
AX15 (4X2) . . . . . . . . . . . . . . . . . . . 3.15 L (3.3 qts.)
AX15 (4X4) . . . . . . . . . . . . . . . . . . . 3.15 L (3.3 qts.)
TRANSFER CASE
SELEC-TRAC 242 . . . . . . . . . . . . . 1.3 L (2.85 pts.)
COMMAND-TRAC 231 . . . . . . . . . . 1.0 L (2.2 pts.)
FRONT AXLE
181–FBI . . . . . . . . . . . . . . . . . . . . 1.48 L (3.13 pts.)
186–FBI . . . . . . . . . . . . . . . . . . . . . . 1.18L (2.5pts.)
REAR AXLE
194–RBI . . . . . . . . . . . . . . . . . . . . 1.66 L (3.5 pts.*)
8-1/4 . . . . . . . . . . . . . . . . . . . . . . 2.08 L (4.4 pts.**)
* When equipped with TRAC-LOK, include 3.5
ounces of Friction Modifier Additive.
** When equipped with TRAC-LOK, include 4
ounces of Friction Modifier Additive.
POWER STEERING
Power steering fluid capacities are dependent on
engine/chassis options as well as steering gear/cooler
options. Depending on type and size of internal
cooler, length and inside diameter of cooler lines, or
use of an auxiliary cooler, these capacities may vary.
Refer to Section 19 of the service manual for proper
fill and bleed procedures.
XJ
LUBRICATION AND MAINTENANCE
0 - 3