Jeep Cherokee 2000 Service Manual - page 1362
FRONT DOOR WATERDAM
REMOVAL
The waterdam is attached to the door inner panel
with a butly adhesive. If cohesive separation of the
butly between the waterdam and door inner panel
occurs during the removal process, cut the strands of
butly with a razor knife or equivalent.
(1) Remove door trim panel.
(2) Disengage clips attaching wire harnesses to the
door inner panel.
(3) Push the harnesses/connectors through the
waterdam and into the door.
(4) Grasp the upper and lower rearward corners of
the waterdam and rapidly peel back the waterdam
from the door inner panel.
(5) Separate the waterdam from the door inner
panel.
INSTALLATION
(1) Route the latch rods through the waterdam.
(2) Position the waterdam on the door, apply adhe-
sive as necessary and press into place.
(3) Route the harnesses/connectors through the
waterdam.
Fig. 21 Window Crank—Typical
1 – WINDOW CRANK REMOVAL TOOL
2 – WINDOW CRANK
Fig. 22 Front Door Trim Panel-Manual Window
1 – U-NUT
2 – DOOR
3 – TRIM PANEL
4 – WINDOW CRANK
5 – SPACER
6 – PUSH-IN FASTENER
Fig. 23 Front Door Trim Panel-Power Window
1 – U-NUT
2 – DOOR
3 – TRIM PANEL
4 – PUSH-IN FASTENER
Fig. 24 Detaching Trim Panel Push-In Fasteners
23 - 34
BODY
XJ
REMOVAL AND INSTALLATION (Continued)