Jeep Cherokee 2000 Service Manual - page 209
(2) Disconnect switch harness.
(3) Remove switch mounting screws (Fig. 11)
(4) Remove the acceleration switch.
INSTALLATION
CAUTION: The
mercury
switch
(inside
the
G-switch), will not function properly if the switch is
installed incorrectly. Verify that the switch locating
arrow is pointing to the front of the vehicle (Fig.
12).
(1) Position switch in mounting bracket.
(2) Install switch mounting bolts and tighten to 3
N·m (27.5 in. lbs.).
(3) Connect harness to switch. Be sure harness
connector is firmly seated.
(4) Move seat back to normal position.
DISASSEMBLY AND ASSEMBLY
HYDRAULIC CONTROL UNIT/CONTROLLER
ANTILOCK BRAKE
DISASSEMBLY
(1) Remove pump motor connector from the CAB.
(2) Remove CAB mounting screws from the HCU
(Fig. 13).
(3) Remove CAB from the HCU.
Fig. 10 New Rear Sensor
1 – REAR SENSOR
2 – AIR GAP SPACER ATTACHED TO SENSOR FACE
Fig. 11 G-Switch Mounting
1 – ACCELERATION SWITCH
2 – SWITCH BRACKET
3 – REAR SEAT CROSSMEMBER
Fig. 12 G-Switch
1 – SWITCH PART NUMBER
2 – ARROW INDICATES FRONT OF SWITCH FOR PROPER
MOUNTING
Fig. 13 CAB Mounting Screws
1 – MOUNTING SCREWS
2 – CAB
XJ
BRAKES
5 - 39
REMOVAL AND INSTALLATION (Continued)