Jeep Cherokee 2000 Service Manual - page 1203
flanged tube ends and straight tube ends are
installed as shown.
(89) Install new gaskets on oil screen and install
screen on valve body. Tighten screen bolts to 10 N·m
(7 ft. lbs.) torque.
(90) Install magnet in oil pan. Be sure magnet
does not interfere with valve body oil tubes.
(91) Apply Threebond
t Liquid Gasket TB1281,
P/N 83504038, to sealing surface of oil pan. Sealer
bead should be at least 3 mm (1/8 in.) wide. Install
pan on case and tighten pan bolts to 7 N·m (65 in.
lbs.) torque.
(92) Install transmission speed sensor rotor and
key on output shaft (Fig. 191).
(93) Install spacer and speedometer drive gear on
output shaft. Then install retaining snap ring (Fig.
192).
(94) Apply bead of Threebond
t Liquid Gasket
TB1281, P/N 83504038, to sealing surface at rear of
case (Fig. 193).
Fig. 187 Aligning Manual Valve, Shift Sector And
Detent Spring
1 – DETENT SPRING
2 – SHIFT SECTOR
3 – VALVE BODY
4 – MANUAL VALVE
Fig. 188 Connecting Transmission Throttle Cable
1 – THROTTLE CABLE
2 – THROTTLE CAM
Fig. 189 Connecting Valve Body Solenoid Wires
1 – SOLENOID WIRE CONNECTORS
Fig. 190 Installing Valve Body Oil Tubes
XJ
AW–4 AUTOMATIC TRANSMISSION
21 - 295
DISASSEMBLY AND ASSEMBLY (Continued)