Jeep Cherokee 2000 Service Manual - page 1074
(18) Remove front and rear clutch units as an
assembly. Grasp input shaft, hold clutch units
together and remove them from case (Fig. 129).
(19) Lift front clutch off rear clutch (Fig. 130). Set
clutch units aside for overhaul.
(20) Remove output shaft thrust washer from out-
put shaft (or from rear clutch hub) (Fig. 131).
(21) Remove output shaft thrust plate and washer
from output shaft hub (Fig. 131).
(22) Remove front band from case (Fig. 132).
(23) Remove extension housing from transmission
case.
(24) Remove governor body and park gear from
output shaft.
(25) Remove output shaft and planetary geartrain
as assembly (Fig. 133). Support geartrain with both
hands during removal. Do not allow machined sur-
faces on output shaft to become nicked or scratched.
Fig. 129 Front/Rear Clutch Assemblies
1 – FRONT BAND
2 – FRONT CLUTCH AND DRUM
3 – TRANSMISSION HOUSING
4 – REAR CLUTCH
Fig. 128 Front Band Strut
1 – BAND LEVER
2 – BAND STRUT
3 – FRONT BAND
Fig. 130 Separating Front Clutch From Rear Clutch
1 – FRONT CLUTCH
2 – REAR CLUTCH
Fig. 131 Output Shaft Thrust Plate and Washer
1 – OUTPUT SHAFT
2 – THRUST PLATE
3 – THRUST WASHER
21 - 166
AUTOMATIC TRANSMISSION—30RH
XJ
DISASSEMBLY AND ASSEMBLY (Continued)