Jeep Cherokee 2000 Service Manual - page 68
Other manuals for Cherokee 2000:
Service Manual
of
1528
UPPER BALL STUD REPLACEMENT
(1) Position tools as shown to remove and install
ball stud (Fig. 26).
LOWER BALL STUD REPLACEMENT
(1) Position tools as shown to remove and install
ball stud (Fig. 27).
KNUCKLE INSTALLATION
(1) Position the steering knuckle on the ball studs.
(2) Install and tighten the bottom retaining nut to
109 N·m (80 ft. lbs.) torque. Install new cotter pin.
(3) Install and tighten the top retaining nut to 101
N·m (75 ft. lbs.) torque. Install new cotter pin.
(4) Install the hub bearing and axle shaft.
(5) Connect the tie-rod or drag link end to the
steering knuckle arm. Refer to Group 2, Suspension,
for proper procedures.
Fig. 26 Upper Ball Stud Remove/Install
3 - 32
TUBE, 181, AND 186 FBI AXLE
XJ
REMOVAL AND INSTALLATION (Continued)